6. Tap "Finish" to complete the leveling process.
7
15
16
14
6
Building
BUILDING OUT OF THE BOX
1. Go back to the main screen on your touch screen and insert
SD card included with your Dremel 3D20.
9
11
10
2. Tap "Build" on the touch screen, tap the SD card option, and
use the up/down arrows to scroll.
3. Tap on the model file you would like to build and tap "Build".
4. Your Dremel 3D20 will align the extruder with the build
platform and will begin heating the extruder.
5. Once the build temperature is reached, your model will
begin to build.
4
Getting Ready to Build
6. Touch screen will display "Object Finished" . Tap the check
box to confirm. Wait until the touch screen indicates that
the extruder temperature is "COOL" .
OBSERVE ALL PROVIDED WARNINGS AND SAFETY
WARNING
WARNING
INSTRUCTIONS WHEN USING THE DREMEL 3D20.
FAILURE TO DO SO MAY RESULT IN FIRE, EQUIPMENT DAMAGE,
REMOVING YOUR OBJECT FROM THE BUILD
PROPERTY DAMAGE OR PERSONAL INJURY.
PLATFORM
7. Wait for the extruder to cool before removing your object.
FILAMENT INSTALLATION
8. With the object still attached, remove build platform from
1. Ensure the power switch is in the off position, remove the lid
the build area.
and remove the build platform.
9. Use your hand to peel your object from the build platform. If
2. Place filament spool onto spool holder with spool being fed from
needed, gently use the object removal tool to remove object
the bottom towards the back of the Dremel 3D20. Insert spool
from build platform.
lock into spool holder and rotate 90 degrees to lock in place.
3. Thread filament through filament guide tube.
4. Insert the filament coming from the filament guide tube into
the extruder intake (top).
6
2
4
3
13
17
12
4. Build Platform
5. Build Platform Clips
NEXT
6. Filament Spool
7.
TURN
LEFT
TO
RAISE
THE BUILD PLATFORM
TURN
RIGHT
TO
LOWER
8. Extruder Tip
BACK
THE BUILD PLATFORM
4
9. Extruder Fan
5
10. Extruder
11. Extruder Intake
12. X-Axis Guide Rails
13. Stepper motor (1 of 3)
14. Z-Axis Guide rail
15. Filament Guide Tube
16. Y-Axis Guide Rails
17. SD card Input
18. USB Input
19 20
18
19. Power Switch
20. Power Input
1
3
LIFT
1
9
Filament
Guide
Filament Spool Holder/Lock
TURN
LEFT
TO
RAISE
THE BUILD PLATFORM
TURN
RIGHT
TO
LOWER
THE BUILD PLATFORM
5
2
5
2
NEXT
BACK
Imprimir página