Constellation audio Virgo Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Amplificador Constellation audio Virgo. Constellation audio Virgo 18 páginas.

Remote control

The remote operates the basic functions of the Virgo II. It does not

operate other Constellation Audio components.

18. Standby/power

Push this button to turn the Virgo II on and off. When you turn the unit

on, it will take a few seconds for the power supply and preamp to warm

up. When the Virgo II is ready for use, its LCD screen will show the most

recently selected input. To put the unit in Standby mode—which will

silence the audio but keep the power supply on so the unit stays

warmed up—press this button again after turning on the power.

Hold this button down for 5 seconds to turn the Virgo II off. The unit will

enter cool-down mode for 10 seconds. During cool-down, no buttons on

the unit or remote will operate.

19. Mute

Press this button to silence the audio temporarily. Because the Virgo II

uses a relay to perform the Mute function, it may take a second or so

for this control to respond. The volume numbers on the LCD will flash

when the preamp is in Mute mode. Press the button again to restore

the sound.

20. Volume up/down

Press these buttons to raise or lower the volume. Each press changes

volume by 1 dB at volumes below -50.0 dB, and 0.5 dB at volumes

above -50.0 dB. Holding the buttons down raises or lowers the volume

quickly.

21. Balance left/right

Press these buttons to shift the balance to the left or right. Each press

changes the balance by 0.1 dB.

22. Input

Press this button to select among the Virgo II's XLR and RCA inputs.

You will have to wait a second or so between pushes of this button,

because for best sound quality the Virgo II uses relays to switch inputs.

23. Phase

Push this to flip the phase of the Virgo II's output signal for the selected

input. Use whichever setting sounds best.