Olympus BH2 Series Desmontaje, limpieza y montaje - Página 19

Navegue en línea o descargue pdf Desmontaje, limpieza y montaje para Microscopio Olympus BH2 Series. Olympus BH2 Series 45 páginas. Phase contrast
También para Olympus BH2 Series: Manual de solución de problemas y ajuste (46 páginas), Desmontaje, limpieza y montaje completos (23 páginas), Desmontaje, limpieza y montaje completos (40 páginas), Manual (6 páginas), Manual de instalación (9 páginas)

Figure 56 – Thoroughly clean slide-mount base (old style)

The older style nosepiece slide mount is now ready to

be reinstalled onto the stand and put back into service

(see

Figure

57).

Figure 57 – Slide-mount parts ready for use (old style)

Servicing the New-Style Slide Mount (BHS/BHT)

This section applies only to the newer style assembly

(see

Figure

49). The older style assembly is covered in

the previous section.

Using a suitable slotted screwdriver, loosen and remove

the stop screw for the nosepiece slide-mount locking

block (see

Figure

58).

Figure 58 – Remove the locking-block stop screw

Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames

Using a suitable slotted screwdriver, loosen and remove

the pivot screw for the nosepiece slide-mount locking

block (see

Figure

59).

Figure 59 – Remove the locking-block pivot screw

Separate the locking block from the slide-mount base

(see

Figure

60).

Figure 60 – Separate locking block from slide-mount base

Using a cotton swab and a suitable solvent (acetone),

thoroughly clean the nosepiece slide-mount base,

paying special attention to the surface upon which the

locking block slides and the dovetail bearing surfaces.

(see

Figure

61).

Figure 61 – Thoroughly clean slide-mount base (new style)

Revision 1

Page 19 of 45