Olympus BH2 Series Démontage, nettoyage et remontage - Page 19
Parcourez en ligne ou téléchargez le pdf Démontage, nettoyage et remontage pour {nom_de_la_catégorie} Olympus BH2 Series. Olympus BH2 Series 45 pages. Phase contrast
Également pour Olympus BH2 Series : Manuel de dépannage et de réglage (46 pages), Démontage, nettoyage et remontage complets (23 pages), Démontage, nettoyage et remontage complets (40 pages), Manuel (6 pages), Manuel d'installation (9 pages)
![Olympus BH2 Series Démontage, nettoyage et remontage](/uploads/products/server2/4281634/4281634.jpg)
Figure 56 – Thoroughly clean slide-mount base (old style)
The older style nosepiece slide mount is now ready to
be reinstalled onto the stand and put back into service
(see
Figure
57).
Figure 57 – Slide-mount parts ready for use (old style)
Servicing the New-Style Slide Mount (BHS/BHT)
This section applies only to the newer style assembly
(see
Figure
49). The older style assembly is covered in
the previous section.
Disassemble the New-Style Slide Mount (BHS/BHT)
Using a suitable slotted screwdriver, loosen and remove
the stop screw for the nosepiece slide-mount locking
block (see
Figure
58).
Figure 58 – Remove the locking-block stop screw
Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames
Using a suitable slotted screwdriver, loosen and remove
the pivot screw for the nosepiece slide-mount locking
block (see
Figure
59).
Figure 59 – Remove the locking-block pivot screw
Separate the locking block from the slide-mount base
(see
Figure
60).
Figure 60 – Separate locking block from slide-mount base
Clean Components of New-Style Slide Mount (BHS/BHT)
Using a cotton swab and a suitable solvent (acetone),
thoroughly clean the nosepiece slide-mount base,
paying special attention to the surface upon which the
locking block slides and the dovetail bearing surfaces.
(see
Figure
61).
Figure 61 – Thoroughly clean slide-mount base (new style)
Revision 1
Page 19 of 45