Siemens Simatic S7-300 Primeros pasos - Página 3

Navegue en línea o descargue pdf Primeros pasos para Equipamiento industrial Siemens Simatic S7-300. Siemens Simatic S7-300 32 páginas. Automation systems, controlling a physical axis
También para Siemens Simatic S7-300: Manual del usuario (34 páginas), Manual (21 páginas), Instrucciones de uso (4 páginas), Instrucciones de uso (5 páginas), Manual (35 páginas), Primeros pasos (8 páginas), Primeros pasos (16 páginas), Descripción de la aplicación (24 páginas), Manual (18 páginas), Manual (32 páginas), Manual de instalación y hardware (20 páginas)

Imprimir página
Siemens Simatic S7-300 Primeros pasos

Table of contents

1
Introduction................................................................................................................................................ 5
2
Preparation ................................................................................................................................................ 7
2.1
Requirements.................................................................................................................................7
2.2
Task ...............................................................................................................................................8
3
Learning units .......................................................................................................................................... 11
3.1
1. Step: Wiring..............................................................................................................................11
3.2
Optionally: Setting up the T station with the help of the wizard ...................................................12
3.3
2. Step: Configuring the CPU 317T-2 DP in HW -Config ............................................................14
3.4
3. Step: Changing the transmission rate at the MPI/DP interface ...............................................16
3.5
4. Step: Vital settings in your DP (DRIVE) configuration .............................................................16
3.6
5. Step: Generating technology system data...............................................................................17
3.7
6. Step: Configuring the drive with HW Config ............................................................................18
3.8
7. Step: Configuring the axis(axes) with S7T Config ...................................................................20
3.9
8. Step: Creating the technology DBs..........................................................................................25
3.10
9. Step: Configuring the drive with SimoComU ...........................................................................26
3.11
10. Step: Controlling the axis with the STEP 7 user program .....................................................29
3.12
11. Step: Trial run ........................................................................................................................30
4
Further information .................................................................................................................................. 31
CPU 317T-2 DP: Controlling a physical axis
Getting Started, 03/2008, A5E00251786-05
3