Siemens Simatic S7-300 시작하기 - 페이지 3

{카테고리_이름} Siemens Simatic S7-300에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens Simatic S7-300 32 페이지. Automation systems, controlling a physical axis
Siemens Simatic S7-300에 대해서도 마찬가지입니다: 사용자 설명서 (34 페이지), 매뉴얼 (21 페이지), 운영 지침 (4 페이지), 운영 지침 (5 페이지), 매뉴얼 (35 페이지), 시작하기 (8 페이지), 시작하기 (16 페이지), 애플리케이션 설명 (24 페이지), 매뉴얼 (18 페이지), 매뉴얼 (32 페이지), 설치 및 하드웨어 매뉴얼 (20 페이지)

페이지 인쇄
Siemens Simatic S7-300 시작하기

Table of contents

1
Introduction................................................................................................................................................ 5
2
Preparation ................................................................................................................................................ 7
2.1
Requirements.................................................................................................................................7
2.2
Task ...............................................................................................................................................8
3
Learning units .......................................................................................................................................... 11
3.1
1. Step: Wiring..............................................................................................................................11
3.2
Optionally: Setting up the T station with the help of the wizard ...................................................12
3.3
2. Step: Configuring the CPU 317T-2 DP in HW -Config ............................................................14
3.4
3. Step: Changing the transmission rate at the MPI/DP interface ...............................................16
3.5
4. Step: Vital settings in your DP (DRIVE) configuration .............................................................16
3.6
5. Step: Generating technology system data...............................................................................17
3.7
6. Step: Configuring the drive with HW Config ............................................................................18
3.8
7. Step: Configuring the axis(axes) with S7T Config ...................................................................20
3.9
8. Step: Creating the technology DBs..........................................................................................25
3.10
9. Step: Configuring the drive with SimoComU ...........................................................................26
3.11
10. Step: Controlling the axis with the STEP 7 user program .....................................................29
3.12
11. Step: Trial run ........................................................................................................................30
4
Further information .................................................................................................................................. 31
CPU 317T-2 DP: Controlling a physical axis
Getting Started, 03/2008, A5E00251786-05
3