Siemens Simatic S7-300 시작하기 - 페이지 5

{카테고리_이름} Siemens Simatic S7-300에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens Simatic S7-300 32 페이지. Automation systems, controlling a physical axis
Siemens Simatic S7-300에 대해서도 마찬가지입니다: 사용자 설명서 (34 페이지), 매뉴얼 (21 페이지), 운영 지침 (4 페이지), 운영 지침 (5 페이지), 매뉴얼 (35 페이지), 시작하기 (8 페이지), 시작하기 (16 페이지), 애플리케이션 설명 (24 페이지), 매뉴얼 (18 페이지), 매뉴얼 (32 페이지), 설치 및 하드웨어 매뉴얼 (20 페이지)

Introduction

This Getting Started contains a practical example guiding you through eleven steps in

commissioning a fully functional application, and showing you how to carry out motion

commands. It is thus a valuable help in getting started with the basic functions of a CPU

317T-2 DP.

Depending on your degree of experience, working through the sample will take between one

and two hours.

Note

This Getting Started presumes that you have connected a SIMODRIVE 611 universal drive

to the DP(DRIVE) interface of the CPU 317T-2 DP In case you do not have a drive, we

recommend you refer to the Getting started documentation "CPU 317T-2 DP: Controlling a

virtual axis

Note

You can also use the CPU 315T-2 DP instead of the CPU 317T-2 DP. To do this, select

CPU 315T-2 DP in HW Config. Otherwise, the configuring steps are the same.

CPU 317T-2 DP: Controlling a physical axis

Getting Started, 03/2008, A5E00251786-05