Dremel 3D40 Idea Builder Instructions - Page 4

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Dremel 3D40 Idea Builder. Dremel 3D40 Idea Builder 5 pages. Clogged heatsink tube replacement
Également pour Dremel 3D40 Idea Builder : Manuel de démarrage rapide (2 pages), Manuel (4 pages), Instructions de service (2 pages)

Imprimer la page

b. Visually judge if the leveling arm is vertical. If not, press

+ to increase angle or – to decrease angle in front of

"down" as shown in Figure 12 below.

Figure 12

c. Press "test" twice to check the orientation after adjust-

ment in vertical position. If not satisfied with the orien-

tation of the arm, repeat step b and c until desired

orientation is achieved in vertical position.

d. Press "test" once to move the arm in the stow position.

e. Visually judge if the leveling arm is exposed like it is

shown in Figure 13 below.

Figure 13

f. If yes, press - to decrease angle in front of "up" as

shown in Figure 14 below.

Figure 14

g. If the arm makes a hitting sound or rebounds back

while stowing, then it is stowing too high. In that case,

press + to increase angle of stowing in front of "up".

The arm should be stowed as shown in the Figure 15

below, such that it doesn't expose or rebound.

h. Once the angles are adjusted for both vertical and

stowing positions, press "next".

4. Next screen, "z gap set: (2/2)" will guide in adjusting the

vertical gap (z gap) between the nozzle tip and the build

plate. The gap will be shown in the black box. Initially the

gap will always show 0 regardless of the true gap between

the nozzle and the build plate.

Figure 16: z gap set screen

a. Press the black box "0". This will cause the machine to

check the present gap between the nozzle tip and build

plate.

b. Use the gage paper (0.15mm thick) provided and

check if it can slide in between nozzle tip and build

plate without putting any vertical force on it.

c. If the gage paper can't enter the gap, press "increase

gap" once (to increase by 0.1mm) and then press the

black button to increase the gap.

d. Repeat step c until gage paper can slide in between

nozzle tip and build plate.

e. If the gage paper can enter easily and there is a big

gap, ignore steps c and d. Use the "decrease gap"

once (to reduce by 0.1mm) and then press black button

to decrease the gap.

f. Repeat step e until gage paper can slide in between

nozzle tip and build plate, but should be snug.

g. Once the gap is adjusted using the gage paper pro-

vided, press "finish" to end this adjustment program.

The machine will get out of the calibration procedure

and the LCD will display "Build On" and then the home

screen. The calibration procedure is complete.

h. Remove the USB stick.

Figure 15