Avtech RMA-SS1-SEN Note d'installation - Page 5
Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Avtech RMA-SS1-SEN. Avtech RMA-SS1-SEN 7 pages. Smoke sensor w/escape light
Également pour Avtech RMA-SS1-SEN : Note d'installation (3 pages)
Imprimer la pageSmoke Sensor (RMA-SS1-SEN)
turns on:
•
A loud, repeating horn pattern will sound: 3 beeps, pause, 3 beeps, pause, etc.
•
The Escape Light will turn on.
•
The LED on the Test/Silence Button will flash once every second.
The sensor may continue to alarm for a few seconds after you release the Test/Silence
button.
If the alarm does not sound during testing, try installing a new battery, and make sure it
is snapped in securely. If it still does not alarm, replace the sensor immediately.
If the Escape Light doesn't light during testing, make sure the bulb is working properly. If
you suspect the bulb is burned out, it is not replaceable.
Clean your Smoke Sensor
Clean the Smoke Sensor at least once a month.
•
You may gently vacuum the outside of the Smoke Sensor using your a vacuum's soft
brush attachment or use a can of clean compressed air.
•
Do not use water, cleaners or solvents as they may damage the unit.
•
If the Smoke Sensor becomes contaminated by excessive dirt, dust and/or grime, and
cannot be cleaned to avoid unwanted alarms, replace the unit immediately.
Relocate your Smoke Sensor if necessary
Relocate the unit if it sounds frequent unwanted alarms. See
document for more information.
Replace the battery
When the battery becomes weak, the Smoke Sensor unit will "chirp" about once a minute,
which is the low battery warning. The low battery warning should last for 30 days, but you
should replace the battery immediately.
Use only the following replacement batteries: Duracell #MN1604, (Ultra) #MX1604, U9VL-
J-P. The unit may not operate properly with other batteries.
Never use rechargeable batteries since they may not provide a constant charge.
Replace Your Smoke Sensor
•
Replace your Smoke Sensor immediately if it is not operating properly.
•
Replace your Smoke Sensor 10 years from date of purchase. You may write the
purchase date on the space provided on back of unit.
Avoid These Locations
Page 5
in this