Avtech RMA-SS1-SEN Note d'installation
Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Avtech RMA-SS1-SEN. Avtech RMA-SS1-SEN 7 pages. Smoke sensor w/escape light
Également pour Avtech RMA-SS1-SEN : Note d'installation (3 pages)
Imprimer la pageAVTECH
AVTECH's Smoke Sensor w/Escape Light is a battery-
powered smoke detector with additional electronics that
allow it to interface with Room Alert as a switch sensor; you
may set up and receive alerts remotely when the switch
state changes to assist your IT staff in monitoring and
protecting your valuable IT equipment.
The Smoke Sensor monitors the air, and when smoke
reaches its sensing chamber, it alarms. This unit will not
sense gas, heat, or flame.
Smoke Sensor Package Contents
•
One (1) Smoke Sensor
•
One (1) 25' speaker cable
•
One (1) 9V alkaline battery
•
Two (2) mounting screws with two (2) plastic screw anchors
Smoke Sensor
Install Your Smoke Sensor
Do not use this sensor in hazardous (classified) locations or life safety applications.
Do not use this sensor as a substitute for a complete fire detection system.
Attach the Smoke Sensor directly to wallboard or flat wall or ceiling surface.
Do not attach the Smoke Sensor to an electrical junction box as this may impair the
sensor's operation.
Smoke Sensor w/Escape Light
Mounting
Bracket
Escape
Light
Temperature & Environment Monitoring... Made Easy!
Swing-out
Battery
Compartment
Test/Silence
Button