HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 14 pages. 1u rackmount tape enclosure
Également pour HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM : Instructions d'installation (2 pages), Manuel d'instructions d'installation (20 pages), Note de mise à jour (14 pages), Instructions d'installation (2 pages), Manuel de référence (46 pages)

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

Note:

is installed in the HP System/e rack. The plenum is not needed if the switch is installed

in an HP 9000 Series or comparable EIA rack.

Verify that the plenum (part number A7346-00001) is preinstalled on the SAN Switch

2/8 before proceeding. The plenum is required for the SAN Switch 2/8 rack mount

only, as it allows air to dissipate at the rear of the rack, preventing overheating.

If the plenum is not preinstalled on the SAN Switch 2/8, refer to the HP StorageWorks

SAN Switch 2/8 Version 3.1.x Installation Guide for complete plenum installation

instructions.

Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum

Addendum Pg

b. For the SAN Switch 2/8, assemble the two inner rails (one on each side)

to the switch and plenum using the appropriate number (from

#8-32 x 3/16-inch Phillips pan-head screws as shown in

The plenum is only a required part of this installation when the SAN Switch 2/8

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

step

5) of

Figure