HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 설치 매뉴얼 - 페이지 12
{카테고리_이름} HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 14 페이지. 1u rackmount tape enclosure
HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 설치 지침 매뉴얼 (20 페이지), 릴리스 노트 (14 페이지), 설치 지침 (2 페이지), 참조 매뉴얼 (46 페이지)
페이지 인쇄
Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit
Note:
is installed in the HP System/e rack. The plenum is not needed if the switch is installed
in an HP 9000 Series or comparable EIA rack.
Verify that the plenum (part number A7346-00001) is preinstalled on the SAN Switch
2/8 before proceeding. The plenum is required for the SAN Switch 2/8 rack mount
only, as it allows air to dissipate at the rear of the rack, preventing overheating.
If the plenum is not preinstalled on the SAN Switch 2/8, refer to the HP StorageWorks
SAN Switch 2/8 Version 3.1.x Installation Guide for complete plenum installation
instructions.
Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum
10
Addendum Pg
b. For the SAN Switch 2/8, assemble the two inner rails (one on each side)
to the switch and plenum using the appropriate number (from
#8-32 x 3/16-inch Phillips pan-head screws as shown in
The plenum is only a required part of this installation when the SAN Switch 2/8
HP StorageWorks SAN Switch 2/8|16|32 Installation Guide
step
5) of
Figure
8.