HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Installatiehandleiding - Pagina 12

Blader online of download pdf Installatiehandleiding voor {categorie_naam} HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 14 pagina's. 1u rackmount tape enclosure
Ook voor HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM: Installatie-instructies (2 pagina's), Handleiding voor installatie-instructies (20 pagina's), Release Release (14 pagina's), Installatie-instructies (2 pagina's), Referentiehandleiding (46 pagina's)

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

Note:

is installed in the HP System/e rack. The plenum is not needed if the switch is installed

in an HP 9000 Series or comparable EIA rack.

Verify that the plenum (part number A7346-00001) is preinstalled on the SAN Switch

2/8 before proceeding. The plenum is required for the SAN Switch 2/8 rack mount

only, as it allows air to dissipate at the rear of the rack, preventing overheating.

If the plenum is not preinstalled on the SAN Switch 2/8, refer to the HP StorageWorks

SAN Switch 2/8 Version 3.1.x Installation Guide for complete plenum installation

instructions.

Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum

Addendum Pg

b. For the SAN Switch 2/8, assemble the two inner rails (one on each side)

to the switch and plenum using the appropriate number (from

#8-32 x 3/16-inch Phillips pan-head screws as shown in

The plenum is only a required part of this installation when the SAN Switch 2/8

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

step

5) of

Figure