Cisco Aironet 521 Manuel - Page 17
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco Aironet 521. Cisco Aironet 521 35 pages. Ip phones with multiplatform firmware
Également pour Cisco Aironet 521 : Manuel de l'utilisateur (46 pages), Manuel de démarrage rapide (26 pages), Manuel (40 pages), Manuel d'administration (48 pages), Manuel d'installation (39 pages), Manuel (24 pages)

Follow these steps to mount your access point on a suspended ceiling:
Step 1
Determine the location on the ceiling where you intend to mount the
access point.
Step 2
Select the appropriate T-rail clip for your suspended ceiling and
open the clip to the maximum.
Step 3
Place the clip over the T-rail and close it to the appropriate (A, B,
or C) detent.
Step 4
Tighten the two T-rail locking screws to prevent the clip from
sliding along the rail.
Step 5
Observe the T-rail width detent letter (A, B, or C) that corresponds
to the T-rail width.
Step 6
Align the corresponding (A, B, or C) holes on the mounting plate
over the T-rail mounting plate holes.
Step 7
Hold the mounting plate and insert a 6 x 32 x 1/4 in. flat head screw
into each of the four corresponding (A, B or C) holes and tighten.
Step 8
If needed, drill or cut a cable access hole large enough for the access
point cables and pull the cables through the hole until you have
about 1 ft. of exposed cables protruding from the hole.
Step 9
Attach the access point to the mounting plate.
Quick Start Guide: Cisco 521 Wireless Express Access Point
17