Cisco Aironet 521 Handmatig - Pagina 17

Blader online of download pdf Handmatig voor {categorie_naam} Cisco Aironet 521. Cisco Aironet 521 35 pagina's. Ip phones with multiplatform firmware
Ook voor Cisco Aironet 521: Gebruikershandleiding (46 pagina's), Snelstarthandleiding (26 pagina's), Handmatig (40 pagina's), Administratiehandleiding (48 pagina's), Installatiehandleiding (39 pagina's), Handmatig (24 pagina's)

Follow these steps to mount your access point on a suspended ceiling:

Step 1

Determine the location on the ceiling where you intend to mount the

access point.

Step 2

Select the appropriate T-rail clip for your suspended ceiling and

open the clip to the maximum.

Step 3

Place the clip over the T-rail and close it to the appropriate (A, B,

or C) detent.

Step 4

Tighten the two T-rail locking screws to prevent the clip from

sliding along the rail.

Step 5

Observe the T-rail width detent letter (A, B, or C) that corresponds

to the T-rail width.

Step 6

Align the corresponding (A, B, or C) holes on the mounting plate

over the T-rail mounting plate holes.

Step 7

Hold the mounting plate and insert a 6 x 32 x 1/4 in. flat head screw

into each of the four corresponding (A, B or C) holes and tighten.

Step 8

If needed, drill or cut a cable access hole large enough for the access

point cables and pull the cables through the hole until you have

about 1 ft. of exposed cables protruding from the hole.

Step 9

Attach the access point to the mounting plate.

Quick Start Guide: Cisco 521 Wireless Express Access Point