Cisco Aironet 521 Manuel - Sayfa 17

IP Telefon Cisco Aironet 521 için çevrimiçi göz atın veya pdf Manuel indirin. Cisco Aironet 521 35 sayfaları. Ip phones with multiplatform firmware
Ayrıca Cisco Aironet 521 için: Kullanıcı Kılavuzu (46 sayfalar), Hızlı Başlangıç Kılavuzu (26 sayfalar), Manuel (40 sayfalar), Yönetim Kılavuzu (48 sayfalar), Kurulum Kılavuzu (39 sayfalar), Manuel (24 sayfalar)

Follow these steps to mount your access point on a suspended ceiling:

Step 1

Determine the location on the ceiling where you intend to mount the

access point.

Step 2

Select the appropriate T-rail clip for your suspended ceiling and

open the clip to the maximum.

Step 3

Place the clip over the T-rail and close it to the appropriate (A, B,

or C) detent.

Step 4

Tighten the two T-rail locking screws to prevent the clip from

sliding along the rail.

Step 5

Observe the T-rail width detent letter (A, B, or C) that corresponds

to the T-rail width.

Step 6

Align the corresponding (A, B, or C) holes on the mounting plate

over the T-rail mounting plate holes.

Step 7

Hold the mounting plate and insert a 6 x 32 x 1/4 in. flat head screw

into each of the four corresponding (A, B or C) holes and tighten.

Step 8

If needed, drill or cut a cable access hole large enough for the access

point cables and pull the cables through the hole until you have

about 1 ft. of exposed cables protruding from the hole.

Step 9

Attach the access point to the mounting plate.

Quick Start Guide: Cisco 521 Wireless Express Access Point