Cisco Aironet 521 Manual - Page 17

Browse online or download pdf Manual for IP Phone Cisco Aironet 521. Cisco Aironet 521 35 pages. Ip phones with multiplatform firmware
Also for Cisco Aironet 521: User Manual (46 pages), Quick Start Manual (26 pages), Manual (40 pages), Administration Manual (48 pages), Installation Manual (39 pages), Manual (24 pages)

Print Page

Follow these steps to mount your access point on a suspended ceiling:

Step 1

Determine the location on the ceiling where you intend to mount the

access point.

Step 2

Select the appropriate T-rail clip for your suspended ceiling and

open the clip to the maximum.

Step 3

Place the clip over the T-rail and close it to the appropriate (A, B,

or C) detent.

Step 4

Tighten the two T-rail locking screws to prevent the clip from

sliding along the rail.

Step 5

Observe the T-rail width detent letter (A, B, or C) that corresponds

to the T-rail width.

Step 6

Align the corresponding (A, B, or C) holes on the mounting plate

over the T-rail mounting plate holes.

Step 7

Hold the mounting plate and insert a 6 x 32 x 1/4 in. flat head screw

into each of the four corresponding (A, B or C) holes and tighten.

Step 8

If needed, drill or cut a cable access hole large enough for the access

point cables and pull the cables through the hole until you have

about 1 ft. of exposed cables protruding from the hole.

Step 9

Attach the access point to the mounting plate.

Quick Start Guide: Cisco 521 Wireless Express Access Point