BobsCNC KL733 Manual - Halaman 11

Jelajahi secara online atau unduh pdf Manual untuk Sistem Kontrol BobsCNC KL733. BobsCNC KL733 18 halaman. X frame assembly
Juga untuk BobsCNC KL733: Panduan Perakitan (12 halaman), Panduan Memulai (9 halaman), Perakitan (20 halaman)

Halaman Cetak
BobsCNC KL733 Manual

Two Ways to Tram the Spindle

The purpose of tramming the spindle is to rotate the spindle so that the router bit is per-
pendicular to the Spoilboard surface as shown below.
The KL7 Series routers have 4 SG25U bearings in slotted holes. There are 8-32
Set Screws that can be used to precisely move any of the 4 SG25U bearings to
rotate the Z Assembly around the X axis so that it is perpendicular to the Spoil-
board surface.
The KL7 Series include shims (if needed) to place between the hub of the SG25U
bearing and the wood frame to rotate the Z Assembly around the Y axis.
Incorrect
ROUTER
Page 11
Correct