BobsCNC KL733 Manuel - Sayfa 11

Kontrol Sistemleri BobsCNC KL733 için çevrimiçi göz atın veya pdf Manuel indirin. BobsCNC KL733 18 sayfaları. X frame assembly
Ayrıca BobsCNC KL733 için: Montaj Kılavuzu (12 sayfalar), Başlangıç Kılavuzu (9 sayfalar), Montaj (20 sayfalar)

Sayfayı Yazdır
BobsCNC KL733 Manuel

Two Ways to Tram the Spindle

The purpose of tramming the spindle is to rotate the spindle so that the router bit is per-
pendicular to the Spoilboard surface as shown below.
The KL7 Series routers have 4 SG25U bearings in slotted holes. There are 8-32
Set Screws that can be used to precisely move any of the 4 SG25U bearings to
rotate the Z Assembly around the X axis so that it is perpendicular to the Spoil-
board surface.
The KL7 Series include shims (if needed) to place between the hub of the SG25U
bearing and the wood frame to rotate the Z Assembly around the Y axis.
Incorrect
ROUTER
Page 11
Correct