BobsCNC KL733 매뉴얼 - 페이지 11

{카테고리_이름} BobsCNC KL733에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BobsCNC KL733 18 페이지. X frame assembly
BobsCNC KL733에 대해서도 마찬가지입니다: 조립 설명서 (12 페이지), 시작하기 매뉴얼 (9 페이지), 어셈블리 (20 페이지)

페이지 인쇄
BobsCNC KL733 매뉴얼

Two Ways to Tram the Spindle

The purpose of tramming the spindle is to rotate the spindle so that the router bit is per-
pendicular to the Spoilboard surface as shown below.
The KL7 Series routers have 4 SG25U bearings in slotted holes. There are 8-32
Set Screws that can be used to precisely move any of the 4 SG25U bearings to
rotate the Z Assembly around the X axis so that it is perpendicular to the Spoil-
board surface.
The KL7 Series include shims (if needed) to place between the hub of the SG25U
bearing and the wood frame to rotate the Z Assembly around the Y axis.
Incorrect
ROUTER
Page 11
Correct