- ページ 11

制御システム BobsCNC KL733のPDF マニュアルをオンラインで閲覧またはダウンロードできます。BobsCNC KL733 18 ページ。 X frame assembly
BobsCNC KL733 にも： 組立マニュアル (12 ページ), スタートマニュアル (9 ページ), 組み立て (20 ページ)

ページを印刷する
BobsCNC KL733 マニュアル

Two Ways to Tram the Spindle

The purpose of tramming the spindle is to rotate the spindle so that the router bit is per-
pendicular to the Spoilboard surface as shown below.
The KL7 Series routers have 4 SG25U bearings in slotted holes. There are 8-32
Set Screws that can be used to precisely move any of the 4 SG25U bearings to
rotate the Z Assembly around the X axis so that it is perpendicular to the Spoil-
board surface.
The KL7 Series include shims (if needed) to place between the hub of the SG25U
bearing and the wood frame to rotate the Z Assembly around the Y axis.
Incorrect
ROUTER
Page 11
Correct