Astria Fireplaces Rhapsody54 Series Panduan Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Perapian Astria Fireplaces Rhapsody54 Series. Astria Fireplaces Rhapsody54 Series 12 halaman. Linear direct-vent fireplaces accessory kits

Halaman Cetak

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES

INSTALLATION INSTRUCTIONS

Complete all steps in the order shown, including the installation

of optional accessories (if applicable).

Remove barrier assembly

1. Remove the barrier assembly by lifting it up to disengage its

notches from tabs and pull directly away from the ﬁ replace.

2. To replace the barrier if damaged, remove the three (3)

screws from the top and bottom and one (1) screw from

each side. Reverse these instructions to install the new

manufacturer's barrier (Figure 2).

Door Trim

Barrier

f i r e - p a r t s . c o m

[CROSS-SECTION]

Figure 2 - Removing the bezel

To remove optional Bezel:

Grasp lower portion of bezel frame and pull forward to release

from bottom of door.

Swing bezel out slightly and lift up to clear top bracket from

door frame.

If Bezel is installed, barrier frame shown in Figure 2 will not be

present.

Remove glass door assembly

1. Remove the three (3) screws securing the lower edge of the

glass door assembly to the ﬁ replace (Figure 3).

2. Grasp the glass door assembly by the sides, swing the lower

edge out, and then lift up to unhook it from the ﬁ replace.

NOTE: Take care not to damage the glass.

3. Set aside the screws and glass door assembly in a secure

location for later reinstallation.

Glass Door Assembly

Figure 3 - Removing the glass door assembly

Remove bafﬂ e from ﬁ replace ﬂ oor, if installed

1. If unpacking the ﬁ replace for the ﬁ rst time, remove the

2. Set aside the bafﬂ e in a secure location for later installation.

Barrier

Flanges

Figure 4 - Removing the bafﬂ e

Access the control compartment

1. Remove the two (2) screws securing the burner assembly

Figure 5 - Releasing the air shutter adjustment rod

2. Remove the control compartment access door and gasket by

Figure 6 - Accessing the control compartment

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

bafﬂ e from ﬁ replace ﬂ oor, where it is packed for shipping

(Figure 4).

Bafﬂ e (as shipped)

to the burner brackets. Carefully slide the burner to the left,

to clear the venturi from the oriﬁ ce. Rotate the burner to

release the air shutter adjustment rod from the air shutter

lever (Figure 5). Lift and remove the burner assembly,

and set aside the screws and burner assembly in a secure

location for later reinstallation.

Air Shutter Rod

removing the twelve (12) screws securing it. Set aside the

screws, door, and gasket for later reinstallation (Figure 6).