Gamma 6004 Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma 6004. Gamma 6004 19 halaman. 6 point mounting
Juga untuk Gamma 6004: Panduan Pemilik (20 halaman), Panduan Pemilik (20 halaman), Panduan Pemilik (20 halaman)

Halaman Cetak
Gamma 6004 Panduan Pemilik
ASSEMBLY INSTRUCTIONS
Turntable Installation
Remove the nuts from underneath of the
turntable. Position the 4 screws over the
flange of the turntable pin. Engaging the
turntable brake helps position the screws.
Attach the turntable to the turntable pin
flange using the 4 included M6 cap screws.
Tighten securely.
Height Adjustment
The turntable height can be adjusted to suit
the stringer. To adjust, loosen the two set
screws on the lower column support post
below the bellows assembly. Adjust the
amount of engagement between the upper
and lower column supports until the desired
height is attained. Make sure that the tension
track is still aligned with the long leg of the
base and tighten the two set screws to lock
the upper support column into place.
5