Fujitsu F2MC-8FX Series Catatan Aplikasi - Halaman 13

Jelajahi secara online atau unduh pdf Catatan Aplikasi untuk Motherboard Fujitsu F2MC-8FX Series. Fujitsu F2MC-8FX Series 23 halaman. 8-bit microcontroller
Juga untuk Fujitsu F2MC-8FX Series: Panduan Pengoperasian (20 halaman), Catatan Aplikasi (12 halaman), Setup Manual (18 halaman), Setup Manual (19 halaman), Setup Manual (30 halaman), Catatan Aplikasi (20 halaman), Catatan Aplikasi (21 halaman), Panduan Pengoperasian (21 halaman), Setup Manual (23 halaman), Panduan Pengguna (24 halaman), Setup Manual (17 halaman)

3.4 Evaluation board

Please set jumper plugs on Evaluation board according to following:

1. Set jumper plugs JP3 and JP4 to the right supply voltage,

depending on your evaluation MCU and MCU board

(1-2: 5V, 2-3: 3.3V)

2. Set analogue power supply jumper plug JP5

(AVCC pin is connected to VCC of evaluation board)

3. Set analogue reference input jumper plug JP6

(AVR pin is connected to VCC of evaluation board)

4. Set analogue power supply (GND) jumper plug JP7

(AVSS pin is connected to VSS of evaluation board)

5. Set operation mode jumper plug JP8

(MOD pin connected to GND -> run mode)

6. Set LED jumper plugs JP1 and JP2 to connect I/O port to LEDs on evaluation

board

MB2146-09 – Installation Guide

Chapter 3 Setting up the Emulation System

Figure 9: jumper settings on evaluation board

- 13 -

Supply only

5V DC!

MCU-AN-395002-E-V10