Fujitsu F2MC-8FX Series Toepassingsnotitie - Pagina 13

Blader online of download pdf Toepassingsnotitie voor {categorie_naam} Fujitsu F2MC-8FX Series. Fujitsu F2MC-8FX Series 23 pagina's. 8-bit microcontroller
Ook voor Fujitsu F2MC-8FX Series: Bedieningshandleiding (20 pagina's), Toepassingsnotitie (12 pagina's), Installatiehandleiding (18 pagina's), Installatiehandleiding (19 pagina's), Installatiehandleiding (30 pagina's), Toepassingsnotitie (20 pagina's), Toepassingsnotitie (21 pagina's), Bedieningshandleiding (21 pagina's), Installatiehandleiding (23 pagina's), Gebruikershandleiding (24 pagina's), Installatiehandleiding (17 pagina's)

3.4 Evaluation board

Please set jumper plugs on Evaluation board according to following:

1. Set jumper plugs JP3 and JP4 to the right supply voltage,

depending on your evaluation MCU and MCU board

(1-2: 5V, 2-3: 3.3V)

2. Set analogue power supply jumper plug JP5

(AVCC pin is connected to VCC of evaluation board)

3. Set analogue reference input jumper plug JP6

(AVR pin is connected to VCC of evaluation board)

4. Set analogue power supply (GND) jumper plug JP7

(AVSS pin is connected to VSS of evaluation board)

5. Set operation mode jumper plug JP8

(MOD pin connected to GND -> run mode)

6. Set LED jumper plugs JP1 and JP2 to connect I/O port to LEDs on evaluation

board

MB2146-09 – Installation Guide

Chapter 3 Setting up the Emulation System

Figure 9: jumper settings on evaluation board

- 13 -

Supply only

5V DC!

MCU-AN-395002-E-V10