Fujitsu F2MC-8FX Series Uygulama Notu - Sayfa 13

Anakart Fujitsu F2MC-8FX Series için çevrimiçi göz atın veya pdf Uygulama Notu indirin. Fujitsu F2MC-8FX Series 23 sayfaları. 8-bit microcontroller
Ayrıca Fujitsu F2MC-8FX Series için: Kullanım Kılavuzu (20 sayfalar), Uygulama Notu (12 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (30 sayfalar), Uygulama Notu (20 sayfalar), Uygulama Notu (21 sayfalar), Kullanım Kılavuzu (21 sayfalar), Kurulum Kılavuzu (23 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Kurulum Kılavuzu (17 sayfalar)

3.4 Evaluation board

Please set jumper plugs on Evaluation board according to following:

1. Set jumper plugs JP3 and JP4 to the right supply voltage,

depending on your evaluation MCU and MCU board

(1-2: 5V, 2-3: 3.3V)

2. Set analogue power supply jumper plug JP5

(AVCC pin is connected to VCC of evaluation board)

3. Set analogue reference input jumper plug JP6

(AVR pin is connected to VCC of evaluation board)

4. Set analogue power supply (GND) jumper plug JP7

(AVSS pin is connected to VSS of evaluation board)

5. Set operation mode jumper plug JP8

(MOD pin connected to GND -> run mode)

6. Set LED jumper plugs JP1 and JP2 to connect I/O port to LEDs on evaluation

board

MB2146-09 – Installation Guide

Chapter 3 Setting up the Emulation System

Figure 9: jumper settings on evaluation board

- 13 -

Supply only

5V DC!

MCU-AN-395002-E-V10