Fujitsu F2MC-8FX Series Uygulama Notu - Sayfa 11

Anakart Fujitsu F2MC-8FX Series için çevrimiçi göz atın veya pdf Uygulama Notu indirin. Fujitsu F2MC-8FX Series 23 sayfaları. 8-bit microcontroller
Ayrıca Fujitsu F2MC-8FX Series için: Kullanım Kılavuzu (20 sayfalar), Uygulama Notu (12 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (30 sayfalar), Uygulama Notu (20 sayfalar), Uygulama Notu (21 sayfalar), Kullanım Kılavuzu (21 sayfalar), Kurulum Kılavuzu (23 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Kurulum Kılavuzu (17 sayfalar)

3.3.2 Jumper settings and switches on MCU board

Please set the following switches and jumpers on the MCU board

1. Set the clock selector switch (SW1-1) to OFF.

2. Set the clock supervisor selector switch (SW1-2) to OFF.

3. Set the APB8 bus output selector switch (SW1-3) to OFF.

4. Set the C-pin selector switch (SW1-4) to OFF.

5. Set the clock input selector switch (SW2) to OFF.

6. Set the product selector switch (SW3) according to table 2.

(set to 0: 100-pin package type for evaluation chip)

7. Set the LVD selector switch (SW4) to OFF (middle).

8. Set the power supply selector switch (SW5) to 3V or 5V.

9. Set the jumper plug S2 to LVD0 (right).

10. Set the jumper plug S1 (1+2) to CB.

11. Mount the main clock oscillator (refer chapter 3.3.3)

12. Mount the sub clock oscillator (refer chapter 3.3.3, not required)

1-4

Figure 7: switch and jumper setting on MCU board

MB2146-09 – Installation Guide

Chapter 3 Setting up the Emulation System

- 11 -

MCU-AN-395002-E-V10