Fujitsu F2MC-8FX Series Application Note - Page 13

Browse online or download pdf Application Note for Motherboard Fujitsu F2MC-8FX Series. Fujitsu F2MC-8FX Series 23 pages. 8-bit microcontroller
Also for Fujitsu F2MC-8FX Series: Operation Manual (20 pages), Application Note (12 pages), Setup Manual (18 pages), Setup Manual (19 pages), Setup Manual (30 pages), Application Note (20 pages), Application Note (21 pages), Operation Manual (21 pages), Setup Manual (23 pages), User Manual (24 pages), Setup Manual (17 pages)

Print Page
Fujitsu F2MC-8FX Series Application Note

3.4 Evaluation board

3.4.1 Jumper settings on Evaluation board

Please set jumper plugs on Evaluation board according to following:
1. Set jumper plugs JP3 and JP4 to the right supply voltage,
depending on your evaluation MCU and MCU board
(1-2: 5V, 2-3: 3.3V)
2. Set analogue power supply jumper plug JP5
(AVCC pin is connected to VCC of evaluation board)
3. Set analogue reference input jumper plug JP6
(AVR pin is connected to VCC of evaluation board)
4. Set analogue power supply (GND) jumper plug JP7
(AVSS pin is connected to VSS of evaluation board)
5. Set operation mode jumper plug JP8
(MOD pin connected to GND -> run mode)
6. Set LED jumper plugs JP1 and JP2 to connect I/O port to LEDs on evaluation
board
6
© Fujitsu Microelectronics Europe GmbH
MB2146-09 – Installation Guide
Chapter 3 Setting up the Emulation System
4
Figure 9: jumper settings on evaluation board
3
- 13 -
2
1
5
Supply only
5V DC!
MCU-AN-395002-E-V10