Dell PowerVault MD3200 Series Panduan Penyebaran - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Penyebaran untuk Penyimpanan Dell PowerVault MD3200 Series. Dell PowerVault MD3200 Series 38 halaman. Storage arrays
Juga untuk Dell PowerVault MD3200 Series: Manual Pembaruan (32 halaman), Petunjuk Pemasangan Rak (2 halaman), Matriks Dukungan (12 halaman), Panduan Instalasi (18 halaman), Panduan Penyebaran (38 halaman), Pembaruan Informasi (1 halaman), Matriks Dukungan (17 halaman), Buku Panduan Teknis (40 halaman), Buku Putih (22 halaman), Panduan Penyebaran (38 halaman)

Halaman Cetak
Dell PowerVault MD3200 Series Panduan Penyebaran

Post Installation Tasks

Before using the PowerVault™ MD3200 Series storage array for the first time,
complete a number of initial configuration tasks in the order shown. These
tasks are performed using the MD Storage Manager (MDSM) software.
1 For out-of-band management, you must set the network configuration for
2 Start MDSM.
3 In the Enterprise Management Window (EMW), go to Setup Add
Downloaded from
www.Manualslib.com
each RAID controller module, including its Internet Protocol (IP) address,
subnetwork mask (subnet mask), and gateway.
NOTE:
You can set the network configuration using a DHCP server.
®
•
On Microsoft
Windows
ProgramsDellMD Storage ManagerModular Disk Storage
Manager Client.
•
On Linux operating systems, click the MD Storage Manager desktop
icon. You can also launch MD Storage Manager in Linux by running
the following commands at the command prompt:
cd
/opt/dell/mdstoragesoftware/mdstoragemanager/c
lient
./SMclient
Storage Array and start the automatic discovery of systems.
NOTE:
Only storage arrays configured with IP address on the same subnet as
the management stations will be detected.
NOTE:
It may take several minutes for the discovery process to complete.
Closing the Automatic Discovery Status window before this stops the
discovery process.
After discovery is complete, a confirmation screen appears. Click Close to
close the screen.
manuals search engine
®
operating systems, click Start
Post Installation Tasks
4
29