Dell PowerVault MD3200 Series Manual de implantação - Página 29

Procurar online ou descarregar pdf Manual de implantação para Armazenamento Dell PowerVault MD3200 Series. Dell PowerVault MD3200 Series 38 páginas. Storage arrays
Também para Dell PowerVault MD3200 Series: Manual de atualização (32 páginas), Instruções de instalação do bastidor (2 páginas), Matriz de apoio (12 páginas), Manual de instalação (18 páginas), Manual de implantação (38 páginas), Atualização da informação (1 páginas), Matriz de apoio (17 páginas), Manual técnico (40 páginas), Livro Branco (22 páginas), Manual de implantação (38 páginas)

Post Installation Tasks

Before using the PowerVault™ MD3200 Series storage array for the first time,

complete a number of initial configuration tasks in the order shown. These

tasks are performed using the MD Storage Manager (MDSM) software.

1 For out-of-band management, you must set the network configuration for

2 Start MDSM.

3 In the Enterprise Management Window (EMW), go to Setup Add

Downloaded from

www.Manualslib.com

each RAID controller module, including its Internet Protocol (IP) address,

subnetwork mask (subnet mask), and gateway.

NOTE:

You can set the network configuration using a DHCP server.

•

On Microsoft

Windows

ProgramsDellMD Storage ManagerModular Disk Storage

Manager Client.

•

On Linux operating systems, click the MD Storage Manager desktop

icon. You can also launch MD Storage Manager in Linux by running

the following commands at the command prompt:

/opt/dell/mdstoragesoftware/mdstoragemanager/c

lient

./SMclient

Storage Array and start the automatic discovery of systems.

NOTE:

Only storage arrays configured with IP address on the same subnet as

the management stations will be detected.

NOTE:

It may take several minutes for the discovery process to complete.

Closing the Automatic Discovery Status window before this stops the

discovery process.

After discovery is complete, a confirmation screen appears. Click Close to

close the screen.

manuals search engine

operating systems, click Start

Post Installation Tasks