Dell PowerVault MD3200 Series 배포 매뉴얼 - 페이지 29

{카테고리_이름} Dell PowerVault MD3200 Series에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3200 Series 38 페이지. Storage arrays
Dell PowerVault MD3200 Series에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (32 페이지), 랙 설치 지침 (2 페이지), 지원 매트릭스 (12 페이지), 설치 매뉴얼 (18 페이지), 배포 매뉴얼 (38 페이지), 정보 업데이트 (1 페이지), 지원 매트릭스 (17 페이지), 기술 매뉴얼북 (40 페이지), 백서 (22 페이지), 배포 매뉴얼 (38 페이지)

Post Installation Tasks

Before using the PowerVault™ MD3200 Series storage array for the first time,

complete a number of initial configuration tasks in the order shown. These

tasks are performed using the MD Storage Manager (MDSM) software.

1 For out-of-band management, you must set the network configuration for

2 Start MDSM.

3 In the Enterprise Management Window (EMW), go to Setup Add

Downloaded from

www.Manualslib.com

each RAID controller module, including its Internet Protocol (IP) address,

subnetwork mask (subnet mask), and gateway.

NOTE:

You can set the network configuration using a DHCP server.

•

On Microsoft

Windows

ProgramsDellMD Storage ManagerModular Disk Storage

Manager Client.

•

On Linux operating systems, click the MD Storage Manager desktop

icon. You can also launch MD Storage Manager in Linux by running

the following commands at the command prompt:

/opt/dell/mdstoragesoftware/mdstoragemanager/c

lient

./SMclient

Storage Array and start the automatic discovery of systems.

NOTE:

Only storage arrays configured with IP address on the same subnet as

the management stations will be detected.

NOTE:

It may take several minutes for the discovery process to complete.

Closing the Automatic Discovery Status window before this stops the

discovery process.

After discovery is complete, a confirmation screen appears. Click Close to

close the screen.

manuals search engine

operating systems, click Start

Post Installation Tasks