- ページ 29

ストレージ Dell PowerVault MD3200 SeriesのPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault MD3200 Series 38 ページ。 Storage arrays
Dell PowerVault MD3200 Series にも：更新マニュアル (32 ページ), ラック取り付け説明書 (2 ページ), サポート・マトリックス (12 ページ), インストレーション・マニュアル (18 ページ), 配備マニュアル (38 ページ), 情報更新 (1 ページ), サポート・マトリックス (17 ページ), テクニカルマニュアルブック (40 ページ), ホワイトペーパー (22 ページ), 配備マニュアル (38 ページ)

Post Installation Tasks

Before using the PowerVault™ MD3200 Series storage array for the first time,

complete a number of initial configuration tasks in the order shown. These

tasks are performed using the MD Storage Manager (MDSM) software.

1 For out-of-band management, you must set the network configuration for

2 Start MDSM.

3 In the Enterprise Management Window (EMW), go to Setup Add

Downloaded from

www.Manualslib.com

each RAID controller module, including its Internet Protocol (IP) address,

subnetwork mask (subnet mask), and gateway.

NOTE:

You can set the network configuration using a DHCP server.

•

On Microsoft

Windows

ProgramsDellMD Storage ManagerModular Disk Storage

Manager Client.

•

On Linux operating systems, click the MD Storage Manager desktop

icon. You can also launch MD Storage Manager in Linux by running

the following commands at the command prompt:

/opt/dell/mdstoragesoftware/mdstoragemanager/c

lient

./SMclient

Storage Array and start the automatic discovery of systems.

NOTE:

Only storage arrays configured with IP address on the same subnet as

the management stations will be detected.

NOTE:

It may take several minutes for the discovery process to complete.

Closing the Automatic Discovery Status window before this stops the

discovery process.

After discovery is complete, a confirmation screen appears. Click Close to

close the screen.

manuals search engine

operating systems, click Start

Post Installation Tasks