HP ProCurve 1600M Panduan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih HP ProCurve 1600M. HP ProCurve 1600M 12 halaman. Redundant power supply
Juga untuk HP ProCurve 1600M: Lembar Spesifikasi (12 halaman), Baca Saya Terlebih Dahulu (8 halaman), Panduan Peninjau (27 halaman), Panduan Tambahan (2 halaman), Panduan Tambahan (2 halaman), Panduan Instalasi (28 halaman), Panduan Instalasi (36 halaman), Panduan Instalasi (28 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (4 halaman), Panduan Pengguna (8 halaman), Suplemen Manual (28 halaman), Baca Saya Terlebih Dahulu (16 halaman), Instalasi dan Penghapusan (2 halaman), Panduan Perencanaan dan Pelaksanaan (40 halaman), Petunjuk Pembongkaran Akhir Masa Pakai Produk (2 halaman), Panduan Instalasi (46 halaman), Panduan Diagnostik (2 halaman), Petunjuk Pembongkaran (2 halaman)

b. Install and tighten the two screws that hold the fan tray in place. (Make sure

you do not overtighten the screws.).

Caution: Make sure you do not leave any loose screws or other

foreign material inside the chassis.

c. From the front of the switch, reach into the opening made by the removed

modules and connect the fan tray cable to the white 9-pin connector on the

switch mother board by pressing it straight onto the connector, all the way in

until it stops.

The cable connector aligns with the top and left side of the large management

module edge connector, as shown in the illustration.

Align the fan tray cable connector

with the corner of the large connector

on the switch board. Then press the

cable connector straight onto the

white 9-pin connector in that location.

Tighten the two screws

just until they are snug.