Cisco ASA 5506-X Panduan Pemasangan Perangkat Keras - Halaman 23

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Perangkat Keras Jaringan Cisco ASA 5506-X. Cisco ASA 5506-X 26 halaman. Threat defense reimage guide
Juga untuk Cisco ASA 5506-X: Panduan Memulai Cepat (10 halaman), Panduan Memulai Cepat (14 halaman), Panduan Penyiapan yang Mudah (11 halaman), Manual Perangkat Lunak (37 halaman), Pasang dan Hubungkan (12 halaman), Panduan Instalasi (46 halaman), Memasang Sasis (10 halaman)

Cisco ASA 5506-X Panduan Pemasangan Perangkat Keras
Mount and Connect the ASA
becomes active. See
console port.
c) Gigabit Ethernet ports – For the network interfaces; use standard RJ-45 Ethernet cables.
Step 2
Connect the power cord to the ASA, and plug the other end to your power source.
The ASA 5506-X does not have an on/off switch; the device powers on when you plug it into a power source.
Note
Step 3
Check the Status LED on the ASA chassis.
When it is solid green, the ASA has passed power-on diagnostics.
What to Do Next
You can now proceed to configuration of the ASA, as described in the Quick Start Guide, found at
www.cisco.com/go/asadocs.

Connect to a Console Terminal or PC

The serial ports provide administrative access to the ASA either with a console terminal or a PC. To configure
the ASA through the CLI, you must establish a connection between the ASA console port and either a terminal
or a PC.
This section describes how to connect to a console terminal or a PC, and contains the following topics:

Connect to the Console Port with Microsoft Windows

You must install a USB device driver the first time a Microsoft Windows-based PC is connected to the USB
serial port on the ASA, otherwise the connection fails.
To uninstall the driver, use the Add Remove Programs utility or the Setup-exe program.
Note
Disconnect the ASA console terminal before uninstalling the driver.
Step 1
Obtain the appropriate driver (Cisco_usbconsole_driver_X_X_zip, where X is a revision number) for your ASA model
from the Cisco
Step 2
Install the driver.
Step 3
Connect a USB 5-pin Mini USB Type B to the USB console port as shown in the following figure.
Online Only
Connect to a Console Terminal or PC, on page 19
Download Software
site, USB Console Software category.
Connect to a Console Terminal or PC
for specific instructions for connecting the
Cisco ASA 5506-X Hardware Installation Guide
http://
19