Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan - Halaman 13

Halaman Cetak

Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.whirlpool.com/help

If you experience

Vibration or Off-Balance

Vibration, rocking, or

Feet may not be in contact with the

"walking"

floor and locked.

Washer may not be level.

Vibration during spinning

Load could be unbalanced.

or washer stopped with

all dial lights flashing

Noises – For normal operating sounds, go to www.whirlpool.com/help.

Clicking or metallic

Objects caught in washer

noises

drain system.

Washer may be draining water.

Gurgling or humming

Humming

The washer is sensing the load size.

Water Leaks

Check the following for

Washer not level.

proper installation:

Fill hoses not attached tightly.

Fill hose washers

Drain hose connection

Check household plumbing for leaks

or clogged sink or drain.

Washer not loaded as

recommended.

Washer not performing as expected

Not enough water

Load not completely covered

in washer

in water.

for assistance and to possibly avoid a service call.

Possible Causes

Solution

Front and rear feet must be in firm contact with floor, and washer

must be level to operate properly. Jam nuts must be tight

against the bottom of the cabinet.

Check floor for flexing or sagging. If flooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See "Level the Washer" in the Installation Instructions.

Load garments in loose heaps evenly around the washplate.

Do not load garments directly over the center of the washplate.

Adding wet items to washer or adding more water to basket

could unbalance washer.

Avoid washing single items. Balance a single item such as a

rug or jeans jacket with a few extra items. If the dial is flashing,

redistribute the load, close the lid, and press START/PAUSE.

Use Bulky Items cycle for oversized, non-absorbent items

such as comforters or poly-filled jackets. Other items are

not appropriate for Bulky Items cycle. See "Cycle Guide."

Item or load not suitable for selected cycle. See "Cycle Guide"

and "Using Your Washer."

Empty pockets before washing. Loose items such as coins

could fall between basket and tub or may block pump.

It may be necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the stainless steel basket.

It is normal to hear the pump making a continuous humming

sound with periodic gurgling or surging as final amounts of

water are removed during the spin/drain cycles.

You may hear the hum of the sensing spins after you have

started the washer. This is normal. Sensing spins will take

several minutes before water is added to the washer.

Water may splash off basket if washer is not level.

Tighten fill-hose connection.

Make sure all four fill hose flat washers are properly seated.

Pull drain hose from washer cabinet and properly secure it to

drainpipe or laundry tub.

Do not place tape over drain opening.

Water can back up out of a clogged sink or drainpipe. Check

all household plumbing for leaks (laundry tubs, drain pipe,

water pipes, and faucets.)

An unbalanced load can cause basket to be out of alignment

and cause water to splash off tub. See "Using Your Washer"

for loading instructions.

This is normal operation for an HE low-water washer. The load

will not be completely underwater. The washer senses load sizes

and adds correct amount of water for optimal cleaning. See

"What's New under the Lid."

IMPORTANT: Do not add more water to washer. Adding water

lifts the garments off the washplate, resulting in less effective

cleaning.