Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan - Halaman 4

Halaman Cetak

Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan

CONTROL PANEL AND FEATURES

Not all features and cycles are available on all models.

POWER BUTTON

Press to turn the washer ON. Pressing once while the

washer is on will cancel the current cycle, pressing twice

will turn the washer OFF.

WASH CYCLE KNOB

Turn the Wash Cycle knob to select a cycle for your laundry

load. See "Cycle Guide" for detailed descriptions of cycles.

TIME/STATUS DISPLAY

The Estimated Time Remaining display shows the time

required for the cycle to complete. Factors such as load

size and water pressure may affect the time shown in

the display. Tightly packed loads, unbalanced loads, or

excessive suds may cause the washer to adjust the cycle

time, as well.

If you have set a delay start to the cycle, the Estimated

Time Remaining display will show the delay time adjusted.

When the cycle is complete, the Done indicator will light

until the lid is opened.

The Lid Lock indicator lights up when the lid is locked

and cannot be opened. If you need to open the lid,

press START/PAUSE. The lid will unlock once the washer

movement has stopped. This may take several minutes

if the load was spinning at high speed. Press START/

PAUSE again to restart the cycle.

ECO MONITOR

Your washer is specially designed to conserve energy

and water. Each cycle, along with any selected options,

will result in different energy and water usage. To use

the Eco Monitor, choose the best cycle for the load being

washed, then adjust temperature and spin speed options

to improve the energy usage within that cycle.

START/PAUSE BUTTON

Press to start the selected cycle; press again to pause

a cycle.

CYCLE OPTIONS

You may add or remove options for each cycle. Not all

options can be used with all cycles, and some are preset

to work with certain cycles.

ECOBOOST

™

The EcoBoost

option allows you to increase your

™

energy savings on your wash cycles. When this option

is used, the wash cycle will use cooler wash water than

the selected cycle and may increase the spin speed

for faster drying.

EXTRA RINSE

This option can be used to automatically add a second

rinse to most cycles.

DEEP CLEAN with HEATER

The Deep Clean with Heater option helps to ensure better

soil and stain removal. Deep Clean uses a heater within

the washer to maintain the selected temperature setting

throughout the wash period. This option will add some

additional time to the cycle based on which temperature

is selected. It is a preset cycle setting on the Sanitary

cycle. Deep Clean with Heater may be selected as an

option with other cycles.

DISPENSERS

Press this button to set the dispensers for Oxi, Fabric

Softener, or both so that the selected laundry product

is added to the load at the correct time.

CYCLE SIGNAL

Use this option to adjust volume of the signal that sounds

at end of cycle. A louder signal is helpful in removing

items as soon as cycle is complete.

Press and hold the CYCLE SIGNAL button to illuminate

the washer basket, making loading and unloading easier.

The light comes on when the lid is opened, and turns

off automatically when the lid is closed or when you

press and hold the button again. If the lid is left open,

the drum light will turn off on its own after a few minutes.

If you turn on the drum light while the lid is closed, it

will not automatically time out. You must press and hold

the CYCLE SIGNAL button again to turn it off.

Drum Light