3D Hobby Shop 59" AJ Slick Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pesawat terbang 3D Hobby Shop 59" AJ Slick. 3D Hobby Shop 59" AJ Slick 20 halaman.

Halaman Cetak
5
Install gear cover plate as shown, with clear tape or thick CA.
Remove covering over horizontal stabilizer slot on both sides of fuselage as shown. Remove covering
over elevator servo opening on LEFT side of the fuselage as shown. You can use a sharp hobby knife or
a soldering iron with a sharp tip. HOWEVER – If you do not have experience using a hot tool to remove
covering, BE CAREFUL. It is very easy to melt the covering too much at the edges, giving a bad
appearance. If you use a hobby knife, make sure it has a fresh, sharp blade.