3D Hobby Shop 59" AJ Slick 설치 매뉴얼 - 페이지 5
{카테고리_이름} 3D Hobby Shop 59" AJ Slick에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 59" AJ Slick 20 페이지.
페이지 인쇄5
Install gear cover plate as shown, with clear tape or thick CA.
Remove covering over horizontal stabilizer slot on both sides of fuselage as shown. Remove covering
over elevator servo opening on LEFT side of the fuselage as shown. You can use a sharp hobby knife or
a soldering iron with a sharp tip. HOWEVER – If you do not have experience using a hot tool to remove
covering, BE CAREFUL. It is very easy to melt the covering too much at the edges, giving a bad
appearance. If you use a hobby knife, make sure it has a fresh, sharp blade.