3E THERMOSALD ISC Panduan Memulai Cepat - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengontrol 3E THERMOSALD ISC. 3E THERMOSALD ISC 20 halaman. Temperature controller for impulse sealing. modular system

Halaman Cetak

NOTE – If calibration problems arise, perform a MASTER RESET procedure starting from stage 5.

To perform a MASTER RESET procedure, use either of the two modes below:

mode 1 – Keep the ARROW DOWN + ARROW UP buttons pressed for 6 seconds.

mode 2 - Keep the external RESET+CALIBRATION buttons pressed for 6 seconds.

The four LEDS on the equipment stay on for 3 seconds

4.4 - PUTTING THE SYSTEM INTO SERVICE – BASIC SETUP + MULTI-LINGUAL PANEL +

POTENTIOMETERS (+RS485 OPTION)

NOTE 1: Perforn the same operations as those described in paragraph 4.3 above.

NOTE 2: To enable the potentiometers, change the MACHINE DATA items = 1, Potentiometers + display.

NOTE 3: Set the maximum pre-heat and heat-seal temperatures by using the control panel. To step them down, adjust the

analog inputs (for resolution see technical note paragraph 4.1).

THERMOSALD ISC – MANUAL QUICK START

Manual cod.: 3ES080x_V5.1_QS_EN

Includes all previous models

Page Nr.

PRE-HEAT POTENT.

HEAT-SEAL POTENT.

CLEAR FAULTS/ RESET

BUTTON

CALIBRATION BUTTON

Rev. 2010 / 03

Tot. Nr . 20