3E THERMOSALD ISC Посібник із швидкого старту - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Контролер 3E THERMOSALD ISC. 3E THERMOSALD ISC 20 сторінок. Temperature controller for impulse sealing. modular system
Друкувати сторінку
NOTE – If calibration problems arise, perform a MASTER RESET procedure starting from stage 5.
To perform a MASTER RESET procedure, use either of the two modes below:
mode 1 – Keep the ARROW DOWN + ARROW UP buttons pressed for 6 seconds.
mode 2 - Keep the external RESET+CALIBRATION buttons pressed for 6 seconds.
The four LEDS on the equipment stay on for 3 seconds
4.4 - PUTTING THE SYSTEM INTO SERVICE – BASIC SETUP + MULTI-LINGUAL PANEL +
POTENTIOMETERS (+RS485 OPTION)
NOTE 1: Perforn the same operations as those described in paragraph 4.3 above.
NOTE 2: To enable the potentiometers, change the MACHINE DATA items = 1, Potentiometers + display.
NOTE 3: Set the maximum pre-heat and heat-seal temperatures by using the control panel. To step them down, adjust the
analog inputs (for resolution see technical note paragraph 4.1).
THERMOSALD ISC – MANUAL QUICK START
Manual cod.: 3ES080x_V5.1_QS_EN
Includes all previous models
Page Nr.
12
PRE-HEAT POTENT.
HEAT-SEAL POTENT.
CLEAR FAULTS/ RESET
BUTTON
CALIBRATION BUTTON
Rev. 2010 / 03
Tot. Nr . 20