3E THERMOSALD ISC Quick Start Manual - Page 12

Browse online or download pdf Quick Start Manual for Controller 3E THERMOSALD ISC. 3E THERMOSALD ISC 20 pages. Temperature controller for impulse sealing. modular system

Print Page

NOTE – If calibration problems arise, perform a MASTER RESET procedure starting from stage 5.

To perform a MASTER RESET procedure, use either of the two modes below:

mode 1 – Keep the ARROW DOWN + ARROW UP buttons pressed for 6 seconds.

mode 2 - Keep the external RESET+CALIBRATION buttons pressed for 6 seconds.

The four LEDS on the equipment stay on for 3 seconds

4.4 - PUTTING THE SYSTEM INTO SERVICE – BASIC SETUP + MULTI-LINGUAL PANEL +

POTENTIOMETERS (+RS485 OPTION)

NOTE 1: Perforn the same operations as those described in paragraph 4.3 above.

NOTE 2: To enable the potentiometers, change the MACHINE DATA items = 1, Potentiometers + display.

NOTE 3: Set the maximum pre-heat and heat-seal temperatures by using the control panel. To step them down, adjust the

analog inputs (for resolution see technical note paragraph 4.1).

THERMOSALD ISC – MANUAL QUICK START

Manual cod.: 3ES080x_V5.1_QS_EN

Includes all previous models

Page Nr.

PRE-HEAT POTENT.

HEAT-SEAL POTENT.

CLEAR FAULTS/ RESET

BUTTON

CALIBRATION BUTTON

Rev. 2010 / 03

Tot. Nr . 20