DSC Power 832 Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Unità di controllo DSC Power 832. DSC Power 832 17. Central station talk / listen module
Anche per DSC Power 832: Manuale di istruzioni (11 pagine), Manuale di istruzioni (18 pagine), Istruzioni per l'utente (2 pagine), Manuale di istruzioni per l'installazione (12 pagine), Manuale d'uso (20 pagine), Istruzioni per l'installazione (2 pagine), Istruzioni per l'installazione (2 pagine)

3.1 Programming via Keypad

The PC5108L can be programmed from a system keypad. To pro-

gram the module, perform the following:

1. Enter [*][8] followed by your Installer's Code.

2. Enter [806] to access PC5108L module programming.

3. Enter a 2-digit number corresponding to the PC5108L

programming section you wish to program. For example, to

program the Module Zone Group Assignment, enter [00].

4. Enter the required data for the selected section. The keypad will

only accept the number of digits required for that section. For

example, Section [00] will accept two digits. The keypad will

confirm a correct entry by sounding two short beeps.

For more information regarding programming the system through

Installer's Programming, refer to Section 4 "How to Program" in your

PC5015 Installation Manual.

3.2 Programming via Downloading

The PC5108L can be programmed via downloading using either of

the following methods:

1. By connecting to the control panel remotely using a modem.

2. By connecting to the control panel directly using the PC-Link.

Both cases require the use of DLS-1 v6.5. For instructions on

downloading using either of these methods, see the Downloading

Manual.