DSC Power 832 설치 매뉴얼 - 페이지 6

{카테고리_이름} DSC Power 832에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC Power 832 17 페이지. Central station talk / listen module
DSC Power 832에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 사용 설명서 (18 페이지), 사용자 지침 (2 페이지), 설치 지침 매뉴얼 (12 페이지), 사용자 설명서 (20 페이지), 설치 지침 (2 페이지), 설치 지침 (2 페이지)

페이지 인쇄

1. How to Program

3.1 Programming via Keypad

The PC5108L can be programmed from a system keypad. To pro-

gram the module, perform the following:

1. Enter [*][8] followed by your Installer's Code.

2. Enter [806] to access PC5108L module programming.

3. Enter a 2-digit number corresponding to the PC5108L

programming section you wish to program. For example, to

program the Module Zone Group Assignment, enter [00].

4. Enter the required data for the selected section. The keypad will

only accept the number of digits required for that section. For

example, Section [00] will accept two digits. The keypad will

confirm a correct entry by sounding two short beeps.

For more information regarding programming the system through

Installer's Programming, refer to Section 4 "How to Program" in your

PC5015 Installation Manual.

3.2 Programming via Downloading

The PC5108L can be programmed via downloading using either of

the following methods:

1. By connecting to the control panel remotely using a modem.

2. By connecting to the control panel directly using the PC-Link.

Both cases require the use of DLS-1 v6.5. For instructions on

downloading using either of these methods, see the Downloading

Manual.