DSC Power 832 Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Блок управления DSC Power 832. DSC Power 832 17 страниц. Central station talk / listen module
Также для DSC Power 832: Руководство по эксплуатации (11 страниц), Руководство по эксплуатации (18 страниц), Инструкция пользователя (2 страниц), Руководство по установке (12 страниц), Руководство пользователя (20 страниц), Инструкции по установке (2 страниц), Инструкции по установке (2 страниц)

3.1 Programming via Keypad

The PC5108L can be programmed from a system keypad. To pro-

gram the module, perform the following:

1. Enter [*][8] followed by your Installer's Code.

2. Enter [806] to access PC5108L module programming.

3. Enter a 2-digit number corresponding to the PC5108L

programming section you wish to program. For example, to

program the Module Zone Group Assignment, enter [00].

4. Enter the required data for the selected section. The keypad will

only accept the number of digits required for that section. For

example, Section [00] will accept two digits. The keypad will

confirm a correct entry by sounding two short beeps.

For more information regarding programming the system through

Installer's Programming, refer to Section 4 "How to Program" in your

PC5015 Installation Manual.

3.2 Programming via Downloading

The PC5108L can be programmed via downloading using either of

the following methods:

1. By connecting to the control panel remotely using a modem.

2. By connecting to the control panel directly using the PC-Link.

Both cases require the use of DLS-1 v6.5. For instructions on

downloading using either of these methods, see the Downloading

Manual.