CTR TMX Series Manuale di allineamento

Sfoglia online o scarica il pdf Manuale di allineamento per Incisore CTR TMX Series. CTR TMX Series 7.

LASER MACHINE MANUFACTURER

To check your laser alignment on a TMX laser machine from CTR, you will need:

a roll of masking tape

The laser machine will need to be turned on during this process, so that the laser can fire

to indicate where the alignment is currently directed. During this process, you should

always close the laser machine lid before pressing the relevant button to fire the

laser, to ensure the laser beam is kept enclosed in the laser machine frame at all times.

Which Controller Do You Have?

•

For RD Controllers with LightBurn software, please ignore the below (Leetro) section

and go to step 1 to complete the following instructions.

•

For Leetro controllers, you must first check the Laser Time Set. To do this;

Press Esc on your laser machine keypad until you are in the home menu and

nothing is highlighted.

ii.

Press Menu > Down Arrow > Enter/Return. The below screen will display.

iii.

Use the up/down arrows to change the Laser Time Set value to 00030 MS.

iv.

Press Enter/Return to set this value and exit this menu, then press Esc to return

to the home menu.

LASER ALIGNMENT GUIDE

TMX machines (rev.1)

IMPORTANT

CTR Future | Instructions | Laser Alignment rev. 10.03.2020 | Page 1 of 7

Enter/Return

button