CTR TMX Series Manuale di allineamento - Pagina 4

Sfoglia online o scarica il pdf Manuale di allineamento per Incisore CTR TMX Series. CTR TMX Series 7.

LASER MACHINE MANUFACTURER

NOT like the above (in the above image, the alignment needs correcting).

The two burn marks should look like a single burn mark on the masking tape.

IMPORTANT: Only turn the brass mirror adjustment screws

each

adjustment, and then re-check the alignment. Turning the screws more than

this can move the laser beam too far and make re-alignment much more difficult.

To do this, you may need to remove the masking tape from the lens assembly and

replace it with a fresh piece of two thicknesses of masking tape, so that you can more

clearly see the burn marks, and to prevent the masking tape catching fire through the

laser firing excessively. If you do this, you will need to fire the laser once in the top left

corner of the bed, to re-create the first burn mark, before moving the laser head to the

front left corner of the bed to continue with the alignment process.

Each time you adjust the brass mirror adjustment screws, you will need to close the lid

and fire again as per the above instructions, to check if the two burn marks are aligned to

the same point.

6. When it looks like the alignment is correct (the two burn marks are on top of each other

on the masking tape), double-check the alignment once more by moving the laser head

to the back left corner of the bed and firing the laser, then moving the laser head to the

front left corner of the bed and firing the laser again.

Make sure the burn marks are indeed aligned (firing to the same point on the masking

tape).

The aim is to have the two burn marks aligned on top of each other,

CTR Future | Instructions | Laser Alignment rev. 10.03.2020 | Page 4 of 7

1/8

of a turn during

1/8th

Turn