CTR TMX Series Manuale di allineamento - Pagina 5

Sfoglia online o scarica il pdf Manuale di allineamento per Incisore CTR TMX Series. CTR TMX Series 7.

LASER MACHINE MANUFACTURER

7. If the two burn marks are aligned correctly, replace the masking tape with two

thicknesses of fresh masking tape on the top left of the laser nozzle.

SECTION 2: Left Hand Mirror

NOTE: During this section of the instructions, you should only adjust the brass mirror

adjustment screws on the back of the mirror on the far left side of the X axis rail (the left

side of the machine, NOT in the back left corner).

8. Move the laser head to the front left corner of the work bed, close the lid and fire the

laser briefly.

9. Move the laser head over to the front right corner of the work area and fire the laser

briefly.

10. Check if the two burn marks are aligned on top of each other on the masking tape. If they

are not aligned correctly, you will need to adjust the brass mirror adjustment screws, and

repeat the process you have used previously until the two burn marks are aligned on top

of each other.

11. Remember to do a final burn mark in the front left corner and then the front right corner

of the laser work area as a final check.

CTR Future | Instructions | Laser Alignment rev. 10.03.2020 | Page 5 of 7