CTR TMX Series Manuale di allineamento - Pagina 6

Sfoglia online o scarica il pdf Manuale di allineamento per Incisore CTR TMX Series. CTR TMX Series 7.

LASER MACHINE MANUFACTURER

SECTION 3: Top Mirror (aka Lens Nozzle Mirror)

NOTE: During this section of the instructions, you should only adjust the brass mirror

adjustment screws at the top of the lens nozzle assembly.

12. To check the laser beam alignment down through the nozzle itself, remove all existing

masking tape from inside the machine, then stick a single thickness of masking tape over

the hole in the bottom of the nozzle (sticky side up against the bottom of the nozzle) –

see image below.

Rub the masking tape against the nozzle with your finger if necessary, so that the hole of

the nozzle is clearly dented into the masking tape (you will need to be able to see where

the circular hole of the nozzle is, when you have removed the masking tape from the end

of the nozzle).

13. Close the lid and fire the laser briefly once. The laser should burn a small hole into the

masking tape. This burn mark should be centrally located through the circular lens

nozzle hole (image below).

CTR Future | Instructions | Laser Alignment rev. 10.03.2020 | Page 6 of 7