Ambient Technologies RCMT Manuale di installazione e istruzioni per l'uso - Pagina 2
Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Telecomando Ambient Technologies RCMT. Ambient Technologies RCMT 7. Manual on/off remote control with timer
Anche per Ambient Technologies RCMT: Istruzioni per l'installazione e il funzionamento (2 pagine)
Stampa la pagina
• Read this manual thoroughly prior to installing, programming or operating any remote control.
• This remote control system is designed for use with a milli-volt or 24V gas valve system. Do not use this
remote control system on applications with voltages above 30 Volts AC.
• This remote control system requires three (3) "AAA" and four (4) "AA" alkaline batteries to power the
transmitter and receiver. Wiring must conform to appliance requirement and building codes/ordinances as
required by local and national code authorities having jurisdiction.
• Do not short (or jumper) across the gas valve terminals to test the remote control installation. This could
damage the unit and void the warranty.
• This remote control system should only be used as described in this manual. Any other use is not
recommended and will void the warranty.
Turn appliance OFF and allow to cool before installing or servicing. DO NOT connect
110-120 VAC wiring to the milli-volt gas control valve. The remote operator must be installed
exactly as outlined in these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any modification of
components will void the warranty and may cause a fire hazard.
Turn appliance OFF (at the appliance or remote receiver) if you are away from your house
for a long period of time.
Remote Receiver
The remote receiver may be wall mounted or installed in the appliance per the
appliance homeowner's manual. Refer to the Homeowner's Manual for
special installation instructions. If wall mounted, the remote receiver must be
installed in a junction box with cover plate provided. Failure to follow the
installation instructions found in the appropriate Homeowner's Manual will void
the warranty and may cause a fire hazard.
Installing Batteries
The remote receiver uses four (4) "AA" batteries. To install batteries,
1. Open the battery door by pressing the two tabs located on the door.
2. Install the batteries as indicated in the receiver.
3. Close the battery door until the door tab snaps in place.
4. To install the receiver into a wall junction box, snap wall cover plate to
the receiver and install the receiver with the screws provided to the
junction box.
5. Gently, install the slide switch back to the receiver stem.
50D0103 RCMT Rel 1 02/10/2006
WARNING
Important Safety Information
INSTALLATIONS
Page 2 of 7
Ambient Technologies
A Division Of Monessen Hearth Systems