Ambient Technologies RCMT Manuale di installazione e istruzioni per l'uso - Pagina 3
Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Telecomando Ambient Technologies RCMT. Ambient Technologies RCMT 7. Manual on/off remote control with timer
Anche per Ambient Technologies RCMT: Istruzioni per l'installazione e il funzionamento (2 pagine)
Stampa la pagina
6. The batteries should be replaced at least once every 6 months or when the battery indicator flashes.
Installing Wire
This system comes with a 22 inch pre-assembled wire assembly. Insert the white terminal to the back of the receiver.
The terminal wire block can only be installed one way. Do not force the terminal plug onto the receiver.
Follow the homeowner's manual for connecting the two (2) 1/4" female spade terminals to the milli-volt valve.
Connect to the two (2) 1/4" female spade wiring terminals.
Make sure that the wires do not contact the appliances any place other than at the terminals.
Exposure to temperatures higher than 105C (250ºF) may cause the receiver to malfunction or
fire hazard.
Remote Transmitter
Installing Batteries
The remote transmitter uses three (3) "AAA" batteries. To install batteries,
1. Press down the battery door tab and lift up and remove the battery door.
2. Install the batteries as indicated on the transmitter cover.
3. Close the battery door by snapping in place.
4. The batteries should be replaced at least once every 6 months or when the battery
indicator flashes.
Setting Privacy (DIP) Switch on Receiver and Transmitter
The remote receiver and transmitter privacy (DIP) switches are preset at the factory. In the event of activation or
interference from other nearby transmissions, reset the code using the following procedure:
1. Slide the code switches on the transmitter or receiver to your choice of ON or OFF position. Switches #1, #2,
#3 and #4 are preset to "ON" for both the transmitter and receiver.
2. The switches on the transmitter and receiver must match in order for the system to work.
3. The system is now ready to operate.
4. See optional 6 hour shutdown on receiver section.
50D0103 RCMT Rel 1 02/10/2006
mV Valve
Receiver
Page 3 of 7
Battery
Door Tab
Back of the Transmitter
Ambient Technologies
A Division Of Monessen Hearth Systems